Q: After cabling, some cables are visually too clearly displayed. Q: You can modify the x and y sizes of a pad in the pad attributes. Q: What should I do if I leave copper dead?Īnswer: normally, this type of problem is not encountered. It takes more than two years, and it has a great leap with protel99se in terms of functionality and scale. Q: Is there any new version available after protel99se?Ī: This version is coming soon. However, it is of little use and the video card is good. Q: Can the 3d feature of 99se be improved more? It seems that you can only look at the front! Can the shape be made by yourself?Ī: You can use ctrl + to flip a 3d image up, down, left, right-click to flip a certain angle. ![]() Q: Is there a good way to set square holes? In addition to drawing on the mechanical layer. Reply: You can add the following content to design -> rules -> clearance constraint: ![]() Q: When filling, assuming that the spacing in the wiring rule is 20 mil, but some of my devices require mil spacing, how can I automatically fill in? Q: Can I use the orcad schematic in protel?Īnswer: You need to generate the network Table file supported by protel from the orcad schematic, and then open it by protel. It is the same as that of the dual-panel. Protel 99 SE Application Technology Q & A q: Can I use automatic cabling for Multilayer circuit boards?Īnswer: Yes.
0 Comments
Leave a Reply. |